Heart Wreath Glowing Fake Pumpkin Carving Design

From pumpkin to porch

1. 1

   Plan the wreath layout

   Divide the pumpkin's equator into 12 equal sections and alternate heart and circle positions. Mark the center of each shape with a dot and check that the bridges between adjacent shapes are at least three-quarters of an inch wide before drawing the full outlines.

2. 2

   Score every shape

   Using the craft knife tip, score each heart outline including the center cleft at the top and the point at the bottom. Score each circle in a single rotating pass. These grooves act as guide rails for the full cut.

3. 3

   Cut the heart openings

   For each heart, cut one lobe at a time from the center cleft down to the bottom point. Keep the knife angled slightly inward so the cut edges are clean on the outside face of the pumpkin. Remove the heart piece and trim any fuzz.

4. 4

   Cut the round holes

   Follow each scored circle with a controlled rotating cut and pop the foam disc free. Keep all round holes the same diameter by using a consistent template or coin throughout.

5. 5

   Inspect all bridges

   After all 12 shapes are cut, press lightly on each bridge section to confirm it is stable. The wreath design distributes stress evenly around the equator, so all bridges should feel equally firm. Reinforce any thin spots with a dot of craft glue from the inside.

6. 6

   Display and photograph

   Place a battery LED inside and set the pumpkin on a garden bench at dusk. The heart-and-dot wreath projects a repeating romantic pattern on nearby surfaces. Photograph from slightly above to capture the full wreath arrangement.

Written with AI to match this design