Peeker the Wrapped Mummy

From pumpkin to porch

1. 1

   Transfer the design and plan your depths

   Since this is an AI concept, you are recreating the look rather than copying a real carve. Print your stencil and tape it snugly to a smooth section of the pumpkin, then poke the outlines with a transfer tool or push pin. Mark which zones stay dark, which get peeled, and which get cut all the way through. Take a photo of your plan so you can check it as bandage curves start to blend together.

2. 2

   Open the pumpkin and thin the wall

   Have an adult cut a lid from the bottom or back so the front face stays intact. Scoop the insides and scrape the carving wall down to about one inch thick where the face and wraps will sit. A thinner wall makes the peeled sections glow more evenly and the cuts easier to control. Keep the rim solid so the structure stays strong.

3. 3

   Shade the round head with skin peeling

   Use a loop or ribbon tool to skin-peel the inside of the round face area for a dim amber glow. Leave the outer border of the hood untouched so it stays dark and frames the head as a clean silhouette. Work slowly and keep the peeled depth consistent so the light spreads evenly. This shading is what separates the glowing face from the dark background.

4. 4

   Cut the eyes and upper bandage curves

   Switch to a fine saw for the two large eyes, cutting just inside your poked lines. Then cut the nested bandage curves below the face, working from the top set downward and leaving a solid bridge between each strip. These bridges are what hold the whole lattice together, so do not rush them. Keep the small round nose opening tidy since it draws the eye to the center.

5. 5

   Carve the lower lattice, diamond last

   Cut the crisscross bandage wraps across the lower torso one opening at a time, checking that each thin strip stays connected on both ends. Leave the small diamond cutout at the center for the very end, since it sits where several load-bearing bridges meet. Cutting it too early can weaken the surrounding strips and cause a collapse. Ease it out gently once everything else is stable.

6. 6

   Light it and take the photo

   Drop in an LED puck or string light rather than a candle so the deep cuts stay safe and cool. Set the light low and slightly back so it fills the eyes and glows through the bandage gaps. Step outside at dusk and adjust the brightness until the wraps read as a lattice against the dark hood. Wipe the cut edges dry and take your photo while the pumpkin is fresh.

Written with AI to match this design