Star Eyes Jack-O-Lantern with Rectangular Tooth Windows

From pumpkin to porch

1. 1

   Map zones and hollow

   Sketch the four face zones top to bottom: double brow area, star eye zone, rectangular mouth band, and negative lower chin area. Cut the lid from the back or top, scoop to one inch of wall, and photograph your layout before cutting.

2. 2

   Cut the rectangular mouth windows

   Score the horizontal top and bottom edges of the mouth band first, then the vertical dividers between each window. Remove each rectangular piece cleanly, leaving every dividing strip fully attached above and below. This step stabilizes the lower half before the large eye apertures remove upper wall material.

3. 3

   Cut the double brow slots

   Add two arching brow cuts per eye, keeping the pair closely spaced so they read together as a double brow. Cut the outer (higher) arc first, then the inner arc directly below it, leaving the thin rind band between them intact.

4. 4

   Cut the large star eyes

   Transfer the star templates to each eye position and cut from center outward on each point. Remove the pieces and confirm that both stars are fully clear. The double brows just above each star now frame the eyes with visible stacked curves.

5. 5

   Add star and diamond accent holes (optional)

   If your design includes additional small star or diamond cutouts flanking the mouth band, cut each one individually, leaving rind between every hole and the nearest window strip. These add scattered points of light without a heavy structural cost.

6. 6

   Light and place

   Set the carved pumpkin on a tree stump or raised surface at night and insert a battery LED. The rectangular windows glow steadily below the star eyes, and if there is any breeze, even a LED can flicker slightly in a vented pumpkin for atmosphere.

Written with AI to match this design