Three Dinosaur Silhouettes Pumpkin with Glowing Openings

From pumpkin to porch

1. 1

   Plan the three-window layout

   Sketch the three window positions lightly in pencil, distributing them evenly across the pumpkin face with at least an inch of solid rind between each window and between each window and the pumpkin edge. Decide which dinosaur occupies which window based on their relative widths.

2. 2

   Transfer the largest figure first

   Pin-transfer the sauropod template, as it is typically the widest, and confirm it fits comfortably in its window without crowding the adjacent windows. Make adjustments to all three positions before committing to the others.

3. 3

   Cut the first dinosaur window and figure

   Saw the open window area around the first dinosaur, leaving the figure retained through its foot connections at the base. Complete this figure fully before moving to the next so you can check the structural result and adjust your approach if needed.

4. 4

   Cut the second and third figures

   Repeat the process for the stegosaurus and T. rex windows. Work each one to completion before starting the next. Confirm that every dinosaur's feet connect firmly to the surrounding rind before removing the surrounding open waste.

5. 5

   Clean all edges and apply petroleum jelly

   Trim any rough spots on all three windows with a craft knife. Coat every cut edge with petroleum jelly. Check that all foot connections are solid and nothing wobbles.

6. 6

   Light at blue hour

   Insert a bright LED puck and place the pumpkin on a garden chair. At blue hour, when ambient sky light is cool and dim, the amber glow from inside makes the retained dinosaurs look almost three-dimensional against their glowing backgrounds.

Written with AI to match this design